Get Support
+91 7291929821, 9711299863
Open Care System (Model : PIANA- D2)
The PIANATM – D 2 open care system comes with automatic manual and baby (Servo) modes. Big separate display for both skin and air temperature. Display can be converted from °C to °F by the push of a button. A big LCD is provided for more information and visualizations of the heater power in manual and servo modes. A full panel of alarms provides safety and convenience, with both audible and visual indicators in the event of:
- High Temp./ Low Temp. • Power Failure • System Fail • Timer -On
- Probe Failure • Heater fail/ON (Optional) only visual alarm provided
Heater Assembly
The heater assembly located above the centre of the support structure consists of an integral examination light and a 650 watts heating system (Silica/ Quartz /Ceramic Heater) for quick warming and even distribution of heat on the baby bed. The heater can be swivelled in either direction for taking X-ray and doing procedures. The Heater is also equipped with LED Phototherapy on both side to provide light intensity effective on the baby bed
Air Mode (Optional)
The system comes with air sensor. This is added security cover with exclusive feature of switching OFF the heater in case the AIR temperature goes above 39°C irrespective of what the skin temperature is at the time of event.
Manual Mode
The system automatically starts heating from 40% in manual mode and the same can be changed through settings up to 100%. The system automatically converts from servo mode to manual mode in case of probe failure thus providing nonstop working of the unit.
Baby Bed
The spacious baby bed incorporates easy drop down/ fold down glasses for maximum access to the patient. Optional: X-Ray facility is provided below the baby bed for taking X-ray of the baby without disturbing
Led Phototherapy
PIANA D comes with choice of highly efficient and bright 12/15 choice of LEDs on each side of the heater. The strong lux of 24/30 LEDs cure jaundice in baby rapidly.
Infant Resuscitator
The range of flow adjustment is 5LPM–15LPM.
The MAX-P and PIP are safe, controlled and accurate. The PEEP is constant and accurate.
- Simple operation and flexible application.
Inbuilt Printer
Manual printer fitted in the unit gives you real time printout of the event when required by pressing the switch on the control unit.
Optional
• Resuscitator • Suction • Oxygen
Technical Specification
| Height | 1850mm |
| Length | 1050mm |
| Width | 650mm |
| Power Supply | 220V/50Hz |
| Heater Power | 650 Watts |
| Fuse | 5 Amp |
If needed the unit can be programmed by the user itself for any of the following features:
(a) Count Up / down Timer.
(b) Check baby Alarm. (OPTIONAL).
(C) Pre warming mode